HP A10500 Series Installation Manual page 39

To power on the switch:
Turn on the power source of the switch to power on the switch.
The following is a sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare.
The Extend BootWare is self-decompressing...................................
.....Done!
****************************************************************************
*
*
*
****************************************************************************
Compiled Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
BASIC CPLD Version
EXTEND CPLD Version : 0.0
PCB Version
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Starting to get the main application file--flash:/ A10500.bin!................
.........................................................................
The main application file is self-decompressing.............................
............................................................................
..Done!
System application is starting...
Starting to get the main application file--flash:/ A10500.bin!................
..........................................................................
The main application file is self-decompressing.............................
............................................................................
............................................................................
.....Done!
System application is starting...
User interface aux0 is available.
Press ENTER to get started.
Press Enter at the prompt. When the prompt
BootWare, Version 1.00
: Jul 1 2010
: XLS408
: 32KB
: 1000MHz
: DDR2 SDRAM
: 1024MB
: 533MHz
: 508KB
: 128MB
: 0.0
: Ver.A
<Sysname>
34
appears, you can configure the switch.
*
*
*