Replacing A Fan Tray - HP A10500 Series Installation Manual

Use one hand to slowly move the card outwards. Supporting the bottom of the card with the other
6.
hand, pull the card out of the slot along slide rails, as shown in callout 3 on
Put the removed card on the antistatic mat.
7.
Install a new card. For the installation procedures, see the chapter
8.
Figure 35 Replacing a card
(1) Loosen the captive screw
(3) Take out the card
NOTE:
If no new card is to be installed, install a blank panel to ensure heat dissipation of the switch and
prevent dust from entering the switch.

Replacing a fan tray

When the fan tray fails, replace the fan tray to ensure normal operation of the switch.
CAUTION:
When replacing the fan tray, do not touch the rotating fans to avoid bodily injury.
The fan trays on the switch can be installed in horizontal or vertical slots.
Vertical slot: A10504 and A10508
•
Horizontal slot: A10508-V
•
The procedures for installing fan trays in the two types of slots are similar. The following section takes a
fan tray installed in a vertical slot on an A10508 as an example.
(2) Move the ejector levers outwards
46
Figure 37.
"Installing modules."