Replacing A Transceiver Module; Replacing An Xfp/Sfp+/Sfp Module; Replacing An Sfp+ Cable - HP A10500 Series Installation Manual

Take out the fan tray from its package.
2.
Holding the handle of the fan tray with one hand and supporting bottom with the other, gently slide
3.
the fan tray along the guide rails into the slot until it is firmly secured in the slot.
Fasten the captive screws on the fan tray.
4.

Replacing a transceiver module

NOTE:
Make sure the optical transceiver modules at the two ends of an optical fiber are of the same model.

Replacing an XFP/SFP+/SFP module

WARNING!
Do not stare at the fibers to avoid hurting your eyes.
•
When installing or removing an XFP/SFP+/SFP module, do not touch the golden finger of the
•
module.
To replace an XFP/SFP+/SFP module:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded. For more information, see the chapter
Remove the optical fibers on the XFP/SFP+/SFP.
2.
Pivot the clasp down to the horizontal position.
3.
Grasp the clasp on the module and carefully pull the module out of the socket.
4.
Put the dust plug on the removed module, and put the remove module into its original shipping
5.
materials.
Install a new XFP/SFP+/SFP module. For the installation procedures, see the chapter
6.
modules."

Replacing an SFP+ cable

To replace an SFP+ cable:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded. For more information, see the chapter
Gently press the SFP+ cable plug in, and then pull the handle on the SFP+ cable outward to pull out
2.
the SFP+ cable plug.
Install a new SFP+ cable. For the installation procedures, see the chapter
3.
NOTE:
Make the bend radius of the SFP+ cable at least eight times of the cable diameter.
•
Replace an SFP+ cable with care. If the SFP+ cable cannot be removed or installed, check that the
•
removal or installation procedures are correct.
"Installing modules."
"Installing modules."
48
"Installing
"Installing modules."