Host Adapter Scsi Id Selection Screen For Aic-7880 - Acer Altos 9100B User Manual

Host Adapter SCSI ID
This option allows you to change the host controller SCSI ID. Figure 5-3 shows
the available IDs for use with the AIC-7880. The default setting is SCSI ID 7. (We
recommend that you not change this setting.) Some operating system software
will not run unless the SCSI controller ID is set at ID 7.
Configuration
SCSI Bus Interface Definitions
Additional Options
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 5-3 Host Adapter SCSI ID Selection Screen for AIC-7880
Each SCSI device on the SCSI bus, including the SCSI controller, must be set to a
unique SCSI ID. The SCSI ID serves two purposes: it uniquely identifies each SCSI
device on the bus, and it determines the device's priority on the bus during the
Arbitration phase. The Arbitration phase determines which device controls the
bus when two or more devices request use of it.
Use the cursor ( ↑ ↓ ) and Enter keys to select the SCSI ID, if you need to change it.
Press Esc at any time to return to the previous menu.
Adaptec AIC7880 Ultra/Ultra W
AIC-7880 Ultra/Ultra W at Bus:Device 01:06h
Host Adapter SCSI ID ................................... 7
SCSI Parity Checking.................................... Enabled
Host Adapter SCSI Termination.................... Disabled
Boot Device Options...................................... Press <Enter>
SCSI Device Configuration............................ Press <Enter>
Advanced Configuration Options................... Press <Enter>
<F6> - Reset to Host Adapter Defaults
SCSISelect (TM)
0
1
2
3
4
5
6
7
*
8
9
10
11
12
13
14
15
Chapter 5–- SCSISelect Configuration Utility 5-7
Utility
*
=default)