System Wake-Up Event
Specifies the event which wakes up the system.
Modem Ring Indicator
This field specifies whether the system can be switched on by an incoming message (e.g. via
modem, fax or telephone). The signal can be supplied externally via serial port 1 or internally via the
Wake-on-LAN or the modem-ring-in connector.
Enabled
The system can be switched on by an incoming message.
The system cannot be switched on by an incoming message.
Disabled
Boot Options
The Boot Options menu specifies the settings for the system startup.
Boot Options
Boot Sequence
st
1
[Floppy Disk]
nd
2
[Hard Disk]
rd
3
[IDE CD-ROM]
First Hard Disk Drive .................. [IDE]
Primary Display Adapter ................ [Auto ]
Fast Boot .............................. [Auto ]
Silent Boot ............................ [Enabled ]
Num Lock After Boot .................... [Enabled ]
Memory Test ............................ [Disabled]
*Configuration Table ................... [Enabled]
*Boot from LSA/BootP boot server ....... [Disabled]
↑↓ = Move Highlight Bar
Esc = Exit
Boot Options
Example for the
Boot Sequence
This field defines the sequence in which the system BIOS searches the drives for system files to
start the operating system. You can change the sequence with the å and ç key.
First Hard Disk Drive
Specifies whether the system is booted from an IDE or an SCSI hard disk drive.
Primary Display Adapter
Primary Display Adapter enables or disables the on-board VGA controller on the system board. If a
screen controller board is installed the on-board controller must be disabled.
A26361-K522-Z122-3-7419
Page 1/1
menu
F1 = Help
→ ← = Change Setting,
BIOS Setup
English - 23