Table of Contents
Advertisement
PCI IRQ Setting
This parameter allows for Auto or Manual configuration of PCI devices. If you
use plug-and-play (PnP) devices, set this parameter to Auto. The system then
automatically assigns IRQ to the PnP devices. If your PCI device is not a PnP,
you can manually assign the interrupt for each device. Refer to your PCI card
manual for more information.
These parameters allow you to specify the appropriate interrupt for each of the
PCI devices. You can assign IRQ3, IRQ4, IRQ5, IRQ7, IRQ9, IRQ10, IRQ11,
IRQ12, IRQ14, or IRQ15 to the slots.
Press
or
to move between fields. Press
This item allows you to manually assign the interrupt for the onboard LAN when
the PCI IRQ Setting parameter is set to Manual. This parameter is grayed and
not user-configurable when the PCI IRQ Setting is set to Auto.
This item allows you to manually assign the interrupt for the first onboard SCSI
device when the PCI IRQ Setting parameter is set to Manual. This parameter is
grayed and not user-configurable when the PCI IRQ Setting is set to Auto and
When the PCI IRQ Setting is set to Auto, all
the IRQ setting fields become gray and non-
configurable.
Make sure that the interrupt you assign in
any of the PCI slots are not used by other
devices to avoid conflicts.
Onboard LAN
Onboard SCSI1
PCI Slots
or
to select options.
Chapter 3 - BIOS Utility 3-29
Advertisement
Chapters
Table of Contents
