Default Settings For Scsi Controller And All Devices - Acer Altos 9100B User Manual

Table 5-1

Default Settings for SCSI Controller and All Devices

Global Settings for SCSI Controller and All Devices
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Boot Device Option
1
Host Adapter BIOS
Support Removable Disks Under BIOS as Fixed Disks
Extended BIOS Translation for DOS Drives > 1 Gbyte
Display <Ctrl-A> Message During BIOS Initialization
BIOS Support for Bootable CD-ROM
BIOS Support for Int13 Extensions
Individual Settings for Each SCSI Device
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Send Start Unit SCSI Command
Initiate Wide Negotiation
1
Settings are valid only if host adapter BIOS is enabled.
2
Do not change this setting from the default.
AcerAltos 9100B Series User's Guide
5-2
1
Default Value
7
Enabled
st
Disable for 1 7880 onboard
nd
Enable for 2 7880 onboard
0 (zero)
Enabled
Boot only
2
Enabled
Enabled
Enabled
Enabled
Default Value
Yes
40 MBytes/sec.
Yes
No
Yes