Table of Contents
Advertisement
1.10
SCSI Feature
The system board features a single-chip SCSI host adapter that adds SCSI
I/O capability to the system. The chipset consists of an onboard
microcontroller, bus master interface controller, and SCSI controllers. A
50-pin Fast SCSI-II interface with 10 MB/s transfer rate and a 68-pin Wide
SCSI interface that transfers at 20 MB/s (Wide SCSI) and 40 MB/s (Ultra
SCSI) are also onboard to accommodate various SCSI devices.
1.10.1
Using the SCSI Feature
Follow these steps to use the SCSI feature:
1.
Install a SCSI device in the system and connect it to the SCSI interface
on the system board. See Figure 1-1 for the location.
2.
Enter the BIOS utility to set the corresponding SCSI parameters.
3.
Enter the SCSI Configuration Utility and make the necessary changes.
Refer to Chapter 3 for information on the SCSI Configuration Utility.
For more information about the installation procedures under different
operating systems, read the README.XXX in the subdirectory of the target
operating system.
System Board
1-25
Advertisement
Table of Contents
