Restoring Default Settings; Importing And Exporting Configuration Settings; Viewing System Information - Interlogix TruVision 10 User Manual

Chapter 14: NVR management
6. When the upgrade process is completed, the NVR reboots automatically.
To update the system firmware via an FTP server:
For engineering purposes only.

Restoring default settings

To restore all parameters to default factory settings:
1. From the menu toolbar, click
2. Click the Default
3. Click the Default
confirm that you want to restore all parameters to default.
 Or 
Click the Restore
confirm that you want to restore all parameters except network settings to default.
Note: Network information, such as IP address, subnet mask, gateway, MTU, NIC
working mode, server port, and default route is not restored to factory default
settings if Restore

Importing and exporting configuration settings

You can export and import configuration settings from a TVN 10. This is useful if you
want to copy the configuration settings to another TVN 10, or if you want to make a
back up of the settings.
Insert an external storage device in the NVR. Go to the
Configurations > Import/Export Configuration File
settings. Click Export
storage device or click
configuration file from the external storage device.

Viewing system information

You can check the current status of the NVR at any time by going to the System
Information menu. You can check the status of the device, cameras, recordings,
alarms, network, and HDDs. See Figure 30 on page 111.
110
System Settings
tab.
button. Enter the Admin password, click OK, and then click
tab. Enter the Admin password, click OK, and then click
is selected.
to export the NVR's configuration settings into an external
Import to import configuration settings after selecting a
> Configurations.
System Settings >
to import or export configuration
TruVision NVR 10 User Manual
Yes to
Yes to