Interlogix TruVision 10 User Manual page 70

Chapter 9: Camera settings
Plug and play cameras are configured automatically with default settings (see
Appendix D "Default menu settings" on page 139). When adjusting the settings of a
plug and play IP camera, the settings remain in place until the camera is
disconnected and reconnected. Upon reconnection, the camera automatically
returns to its default settings.
• Manual: Use this method if the IP cameras are located on a different LAN from the
NVR or are located on the internet.
See Figure 11 below for information on the IP camera window.
Figure 11: IP camera window
Network parameter window
The columns of camera information are: Camera no., Status, Edit, Advanced Set, View, Camera name,
IP Camera Address, Management Port, Protocol, Device Model, Serial Number, and Firmware.
1. Quick Add: Add the selected cameras from
the search results list to the NVR system
without modifying the camera configuration.
2. Search: Search the network for available IP
cameras.
3. Add: After entering the details of a camera in
the configuration window, add it to NVR
system.
4. Upgrade: Upgrade IP camera software. Insert
USB flash drive in NVR and select the file to
download. The camera will automatically
reboot once the software is upgraded.
64
List of IP cameras added to the NVR.
5. Delete: Delete the selected IP camera.
6. Refresh: Update the information displayed on a
camera in the NVR device list.
7. Edit: Change the information on the selected IP
camera.
8. Live View: View the selected IP camera.
9. Camera status indication:
Green = Plug-and-Play cameras; Red =
Disconnected cameras; Yellow = No Plug-and-
Play cameras.
List of IP cameras found on the network
TruVision NVR 10 User Manual