Using The Ir Remote Control - Interlogix TruVision 10 User Manual

Table 4: Mouse buttons
Item Description
Left button Single-Click
Double-Click
Click and Drag
Right button Single-Click
Scroll-wheel Scroll Up
Scroll Down

Using the IR remote control

The NVR is supplied with an infra red (IR) remote control unit. Like the mouse, it can be
used to operate all of the main functions of the NVR.
The IR remote control can be programmed with a unique device ID address so that the
controller will only be able to communicate with NVRs with that address. No
programming is necessary if using a single NVR.
The device ID address only applies when using a remote control and not when using a
keypad.
You can purchase a remote control by ordering part number TVR-REMOTE-1 IR
Remote Control.
Note: The IR remote control is a common accessory for multiple TruVision recorders.
Consequently not all functionality listed for the remote control is available in the
TVN 10.
TruVision NVR 10 User Manual
Live view: Select a camera to display the quick access
toolbar (see "Accessing frequently used commands" on page
74).
Menu: Select a component of a menu, such as a button or an
input field. This is similar to pressing the Enter button on the
remote/front panel controls.
Live view: Switch between single screen and multi-screen
mode in live/ playback mode.
Live view: Drag channel/time bar.
PTZ control: Adjust pan, tilt and zoom.
Tamperproof, privacy masking and motion detection
functions: Select the target area.
Digital zoom-in: Drag and select target area.
Live view: Display menu.
Menu: Exit the current menu and return to higher level.
Live view: Return to the previous window.
Menu: Move the selection to the previous item.
Live view: Move to the next window.
Menu: Move the selection to the next item.
Chapter 4: Operating instructions
19