HIKVISION DS-9100HFI-ST Series User Manual page 19

User Manual of DS-9100HFI-ST Series DVR
10 MENU Button
11 PREV Button
12 DIRECTION/ENTER
Buttons
13
PTZ Button
14
ESC Button
15
RESERVED
16 F1 Button
17 PTZ Control Buttons
18 F2 Button
Troubleshooting Remote Control:
Note: Make sure you have install batteries properly in the remote control. And you have to aim the remote
control at the IR receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to troubleshoot.
Steps:
1. Go into Menu > Settings > General > More Settings by operating the front control panel or the mouse.
2. Check and remember DVR ID#. The default ID# is 255. This ID# is valid for all IR remote controls.
3. Press the DEV button on the remote control.
4. Enter the DVR ID# from step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns green, the remote control is operating properly. If the Status
indicator does not turn green and there is still no response from the remote, please check the following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
If the remote still can't function properly, please change the remote and try again, or contact the device provider.
Same as the MENU/WIPER button on front panel.
Same as the PREV/FOCUS- button on front panel.
Same as the DIRECTION/ENTER buttons on front panel.
Same as the PTZ/IRIS- button on front panel.
Same as the ESC button on front panel.
Reserved for future usage.
Same as the F1/LIGHT button on front panel.
Buttons to adjust the iris, focus and zoom of a PTZ camera.
Same as the F2/AUX button on front panel.
18