Servicing - Falcon Professional + FX User Manual

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

9. Servicing

Fig.9-1
ArtNo.270-0031 - 90 Prof+ FX - Removing the splitter
Fig.9-2
ArtNo.270-0032 - 90 Prof+ FX - Removing the control panel
Fig.9-3
ArtNo.270-0019 - Proplus tags 2
Fig.9-4
ArtNo.090-0021 Hotplate removal
Professional
+ FX
Professional + FX
BEFORE SERVICING ANY GAS CARRYING

COMPONENTS. TURN OFF THE GAS SUPPLY
DO NOT modify this appliance!
Check the appliance is gas sound after completion
of service. When checking for gas leaks DO NOT use
washing up liquid – this can corrode. Use a product
specifically manufactured for leak detection.
DO NOT use reconditioned or unauthorised gas
controls.
Disconnect from the electricity supply before
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
Before electrical reconnection, check that the
appliance is electrically safe.
1. To Remove the Control Panel
Disconnect the cooker from the electricity supply.
Remove all control knobs. Open the oven door. Undo the 4
screws on the oven beak (Fig.9-1). Remove the 3 fixing screws
on the underside of the control. The control panel should drop
down slightly. It is held at each end by two holes in the top
edge (Fig.9-2) that locate on the tags on the inner panel.
Lift the control panel clear of the tags and pull the control
panel forward (Fig.9-3).
Disconnect the wiring from the rear. Lift the panel clear of the
cooker.
Replace all parts in reverse order.
When replacing any electrical connections refer to the wiring
diagram.
2. To Remove the Hotplate
Disconnect the cooker from the electricity supply.
Remove pan supports and burner heads.
Remove the 10 screws holding the hotplate burners to the
hotplate.
Remove the 6 screws holding the hotplate tray to the cooker
(Fig.9-4).
Taking care not to damage the burner heads, lift the hotplate
clear of the cooker.
Reassemble in reverse order, ensuring that the leads are
reconnected correctly.
Check the burner operation.
3. To Remove the Side Panels
Disconnect the cooker from the electricity supply.
Remove the control panel. Undo the 3 screws securing the
plinth and remove.
Undo the lower retaining screw situated below the edge at
the panel front corner. Remove the side panel retaining screw
on the upper front edge and the two fixings on the rear or
the side panel. Remove the panel by pulling it away from the
cooker.
30