Hatteland HD 12T21 MMD User Manual page 63

OSD Menu Functions
Management Settings - Graphic Scaling
|--------3--------
All stretching will performed from center of active display area and outwards in one direction.
Settings as follows:
Management Settings - Graphic Scaling
|--------3--------
All stretch will performed from center of active display area and outwards in one direction.
Settings as follows:
Management Settings
|---2---
Allow to let the video controller always perfom a Automatic Adjustment based on the detected
properties in the incoming signal or when incoming signal sources changes it's properties real time.
It will scale and position incoming signal sources that has changed since the last detection was
executed successfully. Set to either "ON" or "OFF".
● Note: This function is the same as the manual function found in "Image Settings - Auto Position" earlier described.
Default value is "OFF".
User Controls
IND100064-38
"Horizont Stretch"
● Note: Values under or over 50, may cause blurry and unfocused imagery, since it overrides the
external signal's 1.1 pixel information and properties. Default value is 50.
"Vertical Stretch"
● Note: Values under or over 50, may cause blurry and unfocused imagery, since it overrides the
external signal's 1.1 pixel information and properties. Default value is 50.
- Auto Adjustment
- Horizont Stretch
= Zoom/stretch current full screen signal in Horizontal
direction only (left and right). Values from 0 to 100.
- Vertical Stretch
= Zoom/stretch current full screen signal in Vertical direction
only (up and down). Values from 0 to 100.
63