Hatteland HD 12T21 MMD User Manual page 60

OSD Menu Functions
OSD Settings
|---2---
Configuring the OSD Mode to show as simplified/most common functions or advanced (full) setup.
Settings as follows:
"Simplified"
"Full"
● Note: Learn how to navigate and enter the correct code, by reading the "OSD Keycode / OSD Lock Mode"
introduction section earlier in this chapter.
● Note: When requesting a "Full" mode from a Simplified mode, the user are required to enter a key code.
This code is factory preset to "362". You can enter the code by using navigation and "MENU" to confirm. After a
successful entering of the key code, the OSD menu will always be in this state during powered on. After a
power off and on to the unit, the OSD Mode will be reverted back to "Simplified" mode.
OSD Settings
|---2---
To prevent accidental or unwanted user intervention, you can set the behaviour of how the OSD
menu is accessible by the user including adjusting brightness via the "(-) Brilliance (+)" symbols.
Normally by factory default accessible by touching the "MENU" symbol on the front glass of the unit.
Settings as follows:
"Normal Mode"
"Password Protect"
"Full Mode"
● Note: Learn how to navigate and enter the correct code, by reading the "OSD Keycode / OSD Lock Mode"
introduction section earlier in this chapter.
User Controls
IND100064-38
- OSD Mode
= A few functions is not visible/available in this state. For most uses this
is the preferred setting and are safe for the display functionality and
continuous trusted operation on the unit.
= All functions and parameters is visible/available in this state. Some of the
settings adjusted could impact on display functionality and image quality.
Only experienced and qualified personnel should access and change
parameters when in this mode. Also, more technical details about signals,
frequency will be available. The layout of the OSD menu will also change
to a slightly bigger window with more menus and functions available.
- OSD Lock Mode
= Default accessible pop-up by touching the "MENU" symbol.
For Non-ECDIS Compliant usage.
= Ask for key code first (321) when the "MENU" symbol is touched on
the front glass and before the OSD menu will appear.
Required for ECDIS Compliance usage.
= When activated: You will have to touch the "MENU" symbol for 5
seconds after which the key code requester will appear. Note that
only the "MENU" symbol will activate the password request, all other
touches on other symbols are ignored. After key code was entered
and accepted, the OSD menu will appear in which case you have
"x" seconds to use brilliance and power functions before all
functions are deactivated again and returns to "Full Mode".
"x" value is defined as OSD Timeout value (see previous page).
60