Vent Installation; Vent Location; Vent Configurations - Travis Industries 430 GSR2 Owner's Manual

18

Vent Installation

Secure the vent to the insert and termination kit using screws.
Inlet (3" 76mm)
For optimum performance, keep the vent as straight as possible (no 90 bends).

Vent Location


An Exhaust Restrictor is built into the appliance to adjust the flow rate of exhaust gases. This
ensures proper combustion for all vent configurations. Depending upon the vent configuration, you
may be required to adjust the restrictor position. See "Exhaust Restrictor" on page 15.

Vent Configurations

Inlet & E xhaus t R e-L ine
(recommended)
Exhaust
Z.C . (Metal) Wood-B urning F ireplac e
NOTE: You may use either re-line configuration with a masonry or zero-clearance fireplace.
© Travis Industries
Finalizing the Installation
3" (76mm) dia. Gas Liner
Exhaust
(3" 76mm)
Inlet
Direct Vent Cap
6-5/8" to 3" & 3" Colinear
Adapter & Flashing
Inlet
Recommended Block-Off
Plate (non-combustible
metal and/or insulation).
Prevents odors from
chimney entering room.
4140811
Duravent
Chimney Liner
Termination Kit
Exhaust
E xhaus t Only R e-L ine
(not recommended)
Exhaust
Any cracks or damage
inside the chimney
must be repaired
A block-off plate must
seal the intake to the
chimney space. This way
air is drawn down
the chimney for
combustion air.
Block-Off Plate
(non-combustible materials)
Inlet
Mas onry F ireplac e
100-01340