SawStop PCS31230 Owner's Manual page 68

Making Adjustments to Your Saw
Alternate Table Alignment Procedure
For this procedure you will need a set of calipers or a combination square. Begin by removing the table insert
and installing a blade or reference plate as described in the Preferred Table Alignment Procedure. Set the tilt
angle to 0º and raise the blade elevation to approximately 3 inches above the table.
Select a point on the edge of the blade
that is between two consecutive teeth
and place a mark near that point. Rotate
the blade until that mark is just above
the table and toward the front of the saw.
If you are using calipers, measure the
distance between the left edge of the
right-hand miter slot and the left side of
the blade. (Make sure to measure the fl at
combination
plate of the blade rather than the tooth.)
square
If you are using a combination square,
set the end of the ruler fl at against the
right side of the blade, and position the
base to be fl ush against the left side of
the right-hand miter slot (see Fig. 103).
Write the measurement down.
Fig. 103
Now rotate the blade until the point
you marked is just above the table but
toward the back of the saw. Repeat the
measurements above (see Fig. 104). If
necessary, loosen the table mounting
bolts and adjust the position of the table
as described in the Preferred Table
Alignment Procedure. Repeat the above
measurements and table alignment until
you are satisfi ed with the parallelism
between the blade and the miter slot.
Finally, tighten the table mounting bolts.
Fig. 104
66 SawStop 10" Professional Cabinet Saw