Mounting The Accessory Holders - SawStop PCS31230 Owner's Manual

Assembling Your Saw

Mounting the Accessory Holders

8. Your saw comes with two tool holders to store saw accessories. The blade wrench holder provides a place to
hang the wrenches that came with your saw. The accessory tool holder provides a place to store your riving
knife, miter gauge and blade guard. The hardware required to mount the two accessory holders is located
in the area with the gray background on the Table Saw Hardware Pack. To mount the blade wrench holder,
remove the blade wrench holder, one M6 x 12 button head screw and one M6 lock washer from the Table Saw
Hardware Pack. Place the lock washer on the screw, insert the screw through the hole in the blade wrench
holder and then thread the screw into the hole on the left side of the cabinet behind the switch box (see Fig. 30).
Tighten the screw with a 4 mm hex key.
Installing the Handwheels Mounting the Dust Port
Hardware for Steps 2-3 Hardware for Step 4
1 2
Keys, Set Screws, Button Head Screws,
5 x 5 x 25 (2) M6 x 8 (2) 3 M5 x 3 x 15 (3)
Mounting the Extension Wings
Hardware for Step 6
Washers, 7 Lock Washers, M8 (8) 8 Hex Bolts, M8 x 16 (8)
6
M8 (8)
Mounting the Switch Box
Hardware for Step 7
9 Button Head Socket Screws,
M6 x 20 (2)
Washers, M6 (2)
Lock Washers, 11
M6 (2)
10
Switch Box
Blade Spacing
Adjustment Gauge (1)
Hex Key, M8 (1)
Hex Keys: M3 (1), M4 (1), M5 (1), M6 (1)
Tools
F
To install the accessory tool holder, locate the accessory tool holder and remove the other M6 x 12
button head screw and M6 lock washer from the Table Saw Hardware Pack. Place the lock washer on the
screw and insert the screw through the hole at the bottom of the accessory tool holder. Mount the accessory
tool holder to the cabinet by slipping the ends of the hooks on the side of the tool holder into the corresponding
slots on the front lower corner of the right side of the cabinet and threading the screw into the hole in the
cabinet (see Fig. 31). Tighten the screw with a 4 mm hex key.
Mounting
the
Lock Washers, Motor
4 M5 (3)
Cover
Hardware for Step 5
Mounting the
Wrench & Tool
Holders
Hardware for Step 8
Blade
Wrench
Holder
13
14 Lock 15 Button Head
Washers, Screws,
M6 (2) M6 x 12 (2)
Keys (2)
12
Motor
Cover
Rod
5
13
14
15
blade wrench holder
Fig. 30
accessory
tool holder
14 15
Fig. 31
SawStop 10" Professional Cabinet Saw 23