Jam Code Troubleshooting Procedures
D2X
The exit flag actuated unexpectedly exit.
1. Ensure the media is not too thick and that it is supported by the printer.
2. Use a less glossy media.
3. If the drum maintenance unit is near the end of its life, replace it.
4. Clean and inspect the exit rollers.
5. Check the exit flag for proper installation or damage, replace the flag if
necessary.
6. Run the diagnostic Paper Path Drive test.
7. Replace problem component.
D3C
Exit flag time-out during mechanical recovery.
D3M
Exit flag timed out following Tray 2 Pick.
D3N
Exit flag timed out following Tray 3 Pick.
D3P
Exit flag timed out following Tray 4 Pick.
D3Q
Exit flag timed out following Tray 1 Pick.
D3R
Exit flag timed out during duplexing.
D3T
Exit flag time-out during transfix.
1. Inspect the exit path for obstructions.
2. Inspect and clean the exit roller, ensure the exit roller rotates.
3. Inspect and clean the stripper blade.
4. Replace the drum maintenance unit.
5. Run the diagnostic Paper Path Drive test.
E2D
Tray 1 width sensor during warm-up.
E2E
Tray 1 width sensor during
E2Q
Tray 1 width sensor during Tray 1 pick.
1. Examine the Tray 1 width guides for proper movement and ensure the side
guides are not being adjusted while printing.
2. Ensure the front door is closed and the wiring is properly connected and seated.
3. Run the Tray 1 sensor test.
4. Inspect the Tray 1 wiring to the I/O board.
5. Replace the I/O board, then retest.
3-62
(Continued)
Phaser 8400/8500/8550 Color Printer