Install Covers
After checking and adjusting belt tracking follow these
steps to install the covers.
1.
Install foot rails. Position the foot rail into place, then
insert and tighten the four screws (3mm) that secure
the foot rail.
2.
Install rear end caps. Position rear end cap into
place, and then snap the bottom half to secure. Then
insert and tighten the two inside screws (4mm).
3.
Install the top motor cover. Position the top motor
cover into place, then insert and tighten the two well
nuts (3mm). Then insert and tighten the three front
screws (4mm).
Paramount 755T/785T Owner's Manual
69