Tension Walking Belt - Paramount Fitness 7.55T Owner's Manual

Tension Walking Belt

After installing the deck follow these steps to tension
the walking belt.
1. Place a piece of masking tape on the belt near the
right side rear roller slot.
2. Make one mark adjacent to the front edge of the
slot.
3. Make a second mark 0.5 inches (13 mm) in front of
the first mark.
NOTE
The walking belt must not shift while tensioning for this
to be accurate. If the belt does shift, loosen the belt
and start over.
4. Tension the walking belt. Tighten the right retention
bolt (8mm) one half-turn, then tighten the left retention
bolt one half-turn.
5. Repeat until the second mark is adjacent to the
rear roller slot.
Paramount 755T/785T Owner's Manual 67