Set Lift Calibration - Paramount Fitness 7.55T Owner's Manual

Set Lift Calibration

1. [Note: This procedure is not required during initial set up of the treadmill due to
factory calibration] To run lift calibration select Yes.
2. Allow the treadmill to lift to an incline of 10% - this is done automatically by the
treadmill - no user input is needed for this step.
3. Once the lift has stopped moving, measure vertically from the floor to the rear
lower corner of the treadmill [note the measurement] and from the front lower
corner of the treadmill to the floor. Subtract the two numbers and note the
value. Push "clear" on the keypad to erase the number currently displayed.
Now enter the height difference in inches (or cm) using the numeric keypad
when "Input height differences in inches [or cm] " is displayed.
4. Select Enter to accept new value and move to next screen.
Paramount 755T/785T Owner's Manual 30