Table of Contents
Advertisement
BACK PANEL
1. DC POWER INLET:
The Switcher is fi tted with a AC power plug input connector.
Ensure that the used is of an approved type and is of suffi cient
current carrying connector capacity with the correct voltage and
connector polarity. 100~240Volt AC, 50/60Hz power supply.
2. IR EXTENDER CONTROL:
Support one of IR Extender. Extend distance maximum 300
Meters / ~984 feet. When you plug the External IR extender into
the switcher, the front panel IR receiver remain active.
3. RS-232 CONNECTION:
RS-232 control port to allow for interfacing to a PC. Such as a
computer or touch panel control, to the switcher via this DB-9pin
Female connector for serial RS-232 control.
4. ETHERNET CONNECTION:
ETHERNET control port to allow for TCP/IP interfacing to a PC.
Such as a computer or touch panel control (not a web-browser), to
the switcher via this RJ-45 Female connector to control switcher.
BACK PANEL - SWITCH CONTROLS
Power Socket :
Connector Type : IEC 60320 C13
IR Extender Jack:
Remote Port:
Remote Port :
connector
Ethernet Port:
Note: the Ethernet port and RS-232 port cannot
be used simultaneously. Any connection to the
Ethernet port will disable serial commands send
to the RS-232 port.
9
Female Jack - inner OD Ø 3.5mm
D-SUB-9pin Female connector
Control the switcher RJ-45 Female
Advertisement
Table of Contents
