Operation Of Cooling Unit, Fastcool; Mxf Hanging Kit - Kemppi MXF 63 Operating Manual

2.16 Operation of cooling unit, fastCool 10

When FastCool 10 is connected to the FastMig power source for the first time, the cooler
function is normally active. To deselect the cooler function, follow the instructions below
depending on the power source type in use.
fastmig Kms
When leaving the factory, cooling unit status is set 'ON' . If no cooling unit is connected, set the
cooling unit status to 'OFF' . Depending on your panel type follow the instructions described
in the graphic below. Having selected the cooling state required, reset the power source by
switching off at the main on/off switch. Restart the power source and weld.
sf 51/sf 54
ARC FORCE
DYNAMICS
EN
4T
2T
SETUP
MMA
sf 52W/sf 53W
MIG
MMA
SETUP
fastmig pulse
The factory default setting for FastMig Pulse is AUTO. If a cooling unit is not connected and
the operator tries to establish gas cooled operation together with a gas cooled gun, Err 27
is displayed. To establish gas cooled operation, select cooler 'OFF' . This is done in the 'System
Config Menu' as follows: Press the Menu button on the P65 power source panel. Move the
menu display arrow (via panels left-hand up-down arrow keys) to select 'System Config Menu'
and then press select button. Choose 'Water Cooling:Auto' and change via control knob to
setting 'Water Cooling:OFF' , then press Back/Exit. Cooler will then be set to the 'OFF' state for
Gas cooled operation. Reset power source via on/off switch and continue welding.
When selected, the operation of the cooling unit is automatic, starting when welding
commences. When welding stops the pump will continue operation for approx. 5 min,
so reducing the gun and the cooling liquid to ambient temperature. Read the operation
instructions for the FastCool 10 unit.

2.17 mXf hanging kit

The MXF 63, 65 and 67 wire feed units can be hanged from a special hanging kit available as
an accessory. This allows the wire feed unit to be suspended above the work area.
14
FastMig MXF 63, 65, 67
weld
data
WIRE INCH
GAS TEST
m / min
ARC FORCE
DYNAMICS
V
A
ARC FORCE
DYNAMICS
quick
quick
ARC FORCE
setup
setup
DYNAMICS
A + D B
SF 51
> 5 s
MINILOG MINILOG
4T
4T
2T 2T
SETUP SETUP
MMA
MMA
WISE
WISE
1-MIG
1-MIG
MIG
MIG
PEN
SELECT
SELECT MMA
MMA
SYNERGIC
SYNERGIC
PROGRAM
PROGRAM
GAS TEST
U
GAS TEST
weld
ARC FORCE
PANEL
data
DYNAMICS
GAS TEST
GAS TEST WIRE INCH
C
m/min
m/min
mm
mm
A
A
POWER
POWER
MEMORY
MEMORY
SET
SAVE
SET
SET
ch clear
ON
ON
PEN
CH
weld
data
WIRE INCH
V V
U U
SET
SAVE
ch clear
PANEL
PANEL
ch
ch
CH
remote
remote
SF 52W
SF 52W