Fujitsu ETERNUS DX200F Operation Manual page 41

Chapter 6 Troubleshooting
6.1 Check List
■
When the ETERNUS DX Refuses to Turn On
Check the points that are shown below. If the problem cannot be resolved, leave the ETERNUS DX alone and
contact your maintenance engineer.
Is the ETERNUS DX's power cord disconnected?
•
• Is PSU switch of the power supply unit turned to OFF (¡)?
Is there a power failure?
•
■
When the READY LED is not On
If more than ten minutes have passed since the power of the ETERNUS DX was turned on and the READY LED
still has not turned on, contact your maintenance engineer.
■
When the FAULT LED is On
Contact your maintenance engineer.
■
When the FAULT LED Blinks
Check the general status and the system messages in ETERNUS Web GUI. A general status of
cates that the ETERNUS DX contains a component that requires preventive maintenance.
In the details screen for each component, check the detailed information for each component with the
symbol and contact your maintenance engineer.
For details about how to check the general status via ETERNUS CLI, refer to
NUS CLI" (page
■
When the DISK FAULT LED is On
Check the drive status.
If none of these resolve the problem, contact your maintenance engineer.
26).
FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
41
indi-
"3.3 Displaying Status via ETER-
P3AM-8472-01ENZ0