Installation - Martin MiniMAC Wash User Manual

I
NSTALLATION
L O C A T I O N A N D O R I E N T A T I O N
For safe operation, install the MiniMAC in a location where
• it is at least 0.3 meters (12 inches) away from illuminated surfaces and combustible
materials.
• it is not easily touched or bumped.
• it is protected from rain and moisture.
• there is at least 0.1 meters (4 inches) clearance around the fans and air vents.
• there are no flammable materials nearby.
The MiniMAC may be installed in any orientation by means of a rigging clamp (not
included) or placed directly on a stage or floor.
The intense light can burn or melt parts within a distance of 0.3 meters (12 inches).
The MiniMAC is programmed to close its shutter if it illuminates its own base for
more than 10 seconds. When installing fixtures side-by-side, avoid illuminating one
fixture with another.
R I G G I N G
The MiniMAC includes a bracket for attaching a rigging clamp with 12 mm (1/2
in.) hardware. Clamps available from Martin are listed on page 37.
To rig t he f ixt ure
WARNING! Screw the included eye bolt securely into the base and fasten a
safety cable to the eye bolt.
1 Verify that the clamp is undamaged and can bear at least 10 times the weight of
the fixture. Verify that the structure can bear at least 10 times the weight of all
installed fixtures, clamps, cables, auxiliary equipment, etc.
2 Bolt a clamp to the included bracket with a grade 8.8 (minimum) M12 bolt and
lock nut, or as recommended by the clamp manufacturer, through the 13 mm
hole in the bracket.
8

Installation

3