Martin MiniMAC Wash User Manual page 16

R E A D O U T S
The MiniMAC provides readouts to track usage, maintenance intervals, lamp life,
and software version. Values from 1000 to 9999 are automatically scrolled and
counters reset to 0 when they reach 10,000.
Readout
Usage
Lamp usage
Lamp strikes
Software version
To display or reset a readout
1 Scroll to
readout. Press [enter] and scroll to the desired option. Press [enter] to display
the information.
2 (Optional) To reset a counter, press [up] until the readout displays
T E S T P R O G R A M S
Test sequence: This provides an easy way to test all effects without a controller.
Effects return to their home position at the end of the sequence before the test
repeats. To run the test, navigate to
the test, press [menu].
DMX log: Displays the start code and the DMX value received for each effect. This
is useful for troubleshooting set up errors. For example, if the fixture is programmed
for red but projects blue, check the DMX log to find the value received for color. If
the value is for red (see the DMX protocol on page 33) then there is a problem with
the fixture. If the value is for blue, then the problem is with the programming, set
up, or link.
PCb: For service use only. Executing this test with motors connected may cause
damage to the circuit board.
16
Path Option
tot
In f/Hr
rES
tot
Inf /LH r
rES
tot
Inf /LS t
rES
U Er
Table 5: Readouts
Inf
in the main menu, press [enter] and scroll to the desired
Control panel
Displays
Total hours with power on.
Hours with power on since counter was reset.
Recommended for tracking service intervals.
Total hours with lamp on.
Hours with lamp on since counter was reset.
Recommended for tracking lamp life.
Total number of lamp strikes.
Lamp strikes since counter was reset. Helps
evaluate lamp life.
- Version number of installed software.
tSt / tS E
0
/ r un and press [enter]. To stop
.