Martin MiniMAC Wash User Manual page 17

To t est DMX control val ues
1 Program a set of commands for the fixture.
2 Scroll to tSt in the main menu, press [enter] and scroll to
3 Press [enter] to display the start code. The start code must be 0. Press [menu].
4 Scroll through the effects and press [enter] to display the DMX values received.
Compare the values with the DMX protocol.
U P L O A D M O D E
Software upload mode is normally engaged automatically. Use this option only if
automatic upload fails. See "Installing software" on page 29.
M A N U A L A N D A D J U S T M E N T C O N T R O L
The manual control menu (
The adjustment menu (
• To reset the fixture, select
• To turn the lamp on or off, select
• To open, close, and strobe the shutter at 3 speeds, select
• To move the color wheel to each position and scroll it at 3 speeds, select
• To move the gobo wheel to each position rotate gobos, select
• To control pan and tilt, select
S T A N D - A L O N E C O N T R O L
The MiniMAC can be operated without a controller in stand-alone mode. Refer to
"Stand-alone operation" on page 21.
Ctr ) permits limited operation from the control panel.
A dJ ) provides manual control for service use.
rS T
.
LOn LOF
or
PAn and tI L
Control panel
LO g
. Press [enter].
.
S HU .
Gob .
.
COL .
17