Martin MiniMAC Wash User Manual page 29

3 Rinse with distilled water. Mixing the water with a small amount of wetting
agent such as Kodak Photoflo will help prevent streaking and spotting.
4 Dry with a clean, soft and lint-free cloth or blow dry with compressed air.
To cl ean t he f an and air vent s
To maintain adequate cooling, dust must be cleaned from the fan and air vents
periodically.
• Remove dust and dirt from the fans and vent grills using a soft brush, cotton
swab, vacuum, or compressed air.
I N S T A L L I N G S O F T W A R E
Updates of the MiniMAC control software are released when features are added and
improved. The latest version is available for download from the Service and Support
area of the Martin Professional web site at http://www.martin.dk. Software is
installed using a Martin uploader such as the MPBB1 with version 1.4 or later
software.
To inst al l sof tware, normal method
Important! The data link must be terminated as described on page 19.
1 Download the latest control software from the Martin Professional web site at
http://www.martin.dk. Install the software in a Martin MPBB1 uploader.
2 Connect the uploader to the fixture as you would a controller. Apply power to
the uploader and the fixtures.
3 After the fixture has finished resetting, select
and press [enter]. Select
installed when the MPBB1 displays
disconnect the MPBB1.
4 If a check-sum error (
interrupted or corrupted during transmission. Reattempt the upload using
backup method I.
To inst al l sof tware, backup met hod I
Follow this procedure exactly as described to install software if a normal upload
attempt is unsuccessful and a check-sum error (
1 Disconnect the fixture from power: it must be off at least 10 seconds. Do not
apply power to the fixture until the uploader is connected and ready.
d M X
and press [enter]. Wait. The software has been
d ONE
C SE
) occurs and/or the fixture does not reset, data was
Basic service
UPL d
from the uploader menu
and the fixtures reset. Turn off and
C SE ) occurs.
29