Martin MiniMAC Wash User Manual page 30

2 Connect the uploader to the fixture as you would a controller. Terminate the
link .
3 Select
press [enter] yet.
4 Apply power to the fixture. The control panel displays
b
. When
5 Wait. The software has been installed when the MPBB1 displays
the fixture resets. Disconnect the uploader.
To inst all sof tware, backup method II
Use this procedure to install software only if all else fails.
1 Disconnect the fixture from the data link and power.
2 Use tweezers to move the jumper on
PL107 on the main circuit board to the
boot setting as shown.
3 Select
and press [enter]. Select
press [enter] yet.
4 Connect the uploader to the fixture as
you would a controller. Terminate the link .
5 Apply power to the fixture and wait 5 seconds.
6 Press [enter] on the MPBB1. Wait. The software has been installed when the
MPBB1 displays
7 Disconnect the fixture from power and move the jumper back to the normal
setting.
30
UP Ld
from the uploader menu and press [enter]. Select
b
is displayed, wait 5 seconds and then press [enter] on the MPBB1.
U PLd
from the uploader menu
bo ot
dON E
and the fixture resets.
. Do not
normal setting
Basic service
boo t
. Do not
CS E b SL
, then , then
dO NE
boot setting
and