Polycom VMC 1000 Getting Started Manual page 38

Video Media Center - VMC 1000 Getting Started Guide
34
12 Type help to get a list of commands.
A list of commands appears.
13 From the command line, modify the following network settings, as
required:
— Show system information by entering: show.
— Set the password to enter this serial port interface by entering: set
password (and then enter your password twice to verify).
NOTE: Changing the password here only changes the password for this serial
connection. It DOES NOT change the password for the VMC 1000 Administrator
UI.
— Change the IP address of the VMC 1000 by entering: set lan1 static <IP
address> mask <IP address> gw <gateway address>
— Shut down the server by entering: shutdown.
— Reboot the server by entering: reboot.
— Show a list of commands by entering: help or ?
— Log out of the VMC 1000 serial port interface by entering: quit
Polycom, Inc.