Table of Contents
Advertisement
4/32B SAN Switch LEDs
The 4/32B SAN Switch model integrates the following LEDs:
•
System Status LED
•
Power Status LED
•
Port Status LEDs (32), one for each FC port, located directly above the ports
•
Power Supply status LED on each power supply FRU, in the upper right corner
Figure 28
and
1
4
3
1. System Status LED
3. System Power LED
Figure 28 4/32B SAN Switch port side LEDs
Table 17 4/32B SAN Switch LED patterns during normal operation
LED name
Power Supply
Status
Table 17
identify the port side LEDs.
2
LED color
Hardware status
No light
Power supply is not receiving
power or power is off.
Steady green
System is on and power supplies
are functioning properly.
Steady
Power supply fault for one of the
amber (for
following reasons:
more than 5
Power cable is disconnected.
seconds)
Power supply is off. Power supply
has failed.
During POST, the LED displays
amber.
2. Port Status LED
4. Power Supply Status LED
Recommended action
Verify that the power supply is on
and seated and the power cord is
connected to a functioning power
source.
No action required.
Try the following:
Check the power cable connection.
Verify that the power supply is
powered on.
Replace the power supply.
SAN Switch installation guide
25274a
85
Advertisement
Table of Contents
