HP AA-RWF3A-TE Installation Manual page 55

NOTE:
Figure 20 shows the 4/16 SAN Switch; however, this procedure is similar
for all SAN Switches.
3. Close any serial communication programs running on the workstation.
4.
Open a terminal emulator application (such as HyperTerminal on a PC or TERM in
a UNIX environment) and configure the application as follows:
• In a Windows 95, 98, 2000, or NT environment:
• 9600 bits per second
• 8 data bits
• No parity
• 1 stop bit
• No flow control
• In a UNIX environment, enter the following at the prompt:
tip/dev/ttyb –9600
SAN Switch installation guide
55