Table 14
describes the 4/32 SAN Switch nonport side LEDs.
Table 14 4/32 SAN Switch nonport side LED patterns
LED name
Power Supply
Status
Fan Status
4/64 SAN Switch port side LEDs
The 4/64 SAN Switch integrates the following port side LEDs:
•
System Status LED
•
Power Status LED
•
Two Ethernet Port LEDs
•
One Port Status LED
•
Port Speed LED for each port on the switch. These LEDs are displayed below
each pair of Fibre Channel ports. The LEDs are located in the array in the same
relative positions as the ports.
Figure 26
on page 80 identifies the LEDs on the port side of the switch.
15
on page 81 describes the port side LED patterns.
LED color
Hardware status
No light
Power supply is not receiving
power or power is off.
Steady green
Power supply is operating
normally.
Steady amber
Power supply fault for one of
(for more than
the following reasons:
5 seconds)
Power cable is disconnected.
Power supply is off.
Power supply has failed.
No light
Fan assembly is not receiving
power.
Steady green
Fan assembly is operating
normally.
Steady amber
One or more of the fans in the
(for more than
fan assembly failed or the fan
5 seconds)
FRU was disabled by the user.
Recommended action
Verify that the power supply is on
and seated and the power cord is
connected to a functioning power
source.
No action required.
Try the following:
Check the power cable connection.
Verify that the power supply is
powered on.
Replace the power supply.
Verify that the fan assembly is seated
in the switch.
No action required.
Verify that the fan FRU is enabled.
If the fan FRU is enabled, the FRU is
faulty and should be replaced.
Table
SAN Switch installation guide
79