Table of Contents
Advertisement
Table 3
identifies the carton contents included with your SAN Switch.
Table 3 SAN Switch shipping carton checklist
Number
1
2
3
36
Installing and configuring SAN Switches
Description
One SAN Switch Accessories Box containing:
•
One 3.0 m (10 ft) RS-232 serial cable; convertible to an RJ-45 connector by
removing the adapter on the end of the cable
•
Plenum (not shown) — An air duct that attaches to the switch rails, enabling
the switch to draw cooler air into the switch from outside the rack, rather than
drawing in heated air from within the rack. SAN Switches that require a
plenum include:
— SAN Switch 2/16V
— SAN Switch 2/16
— 4/8 SAN Switch
— 4/16 SAN Switch
— 4/32B SAN Switch
•
SAN Switch Rack Mount Kit hardware contained in plastic pouches:
• 14 #8-32 x 3/16-inch Phillips pan-head screws with thread lock for the
SAN Switch 2/32 (requires twelve screws, six per rail)
• 14 #8-32 x 5/16-inch pan-head SEMS screws for use with the 4/8,
4/16, 4/32, 4/32B and 4/64 SAN Switches (All require ten screws
except for the 4/32B SAN Switch which requires six screws)
• Ten #10-32 x 1/2-inch Phillips pan-head screws with captive star
lock-washers
• Eight #10 alignment washers
• Eight #10 adapter washers
• Two 1/4-20 hex nuts with captive star lock-washers
• Two 1/4-inch flat washers
• Four rubber feet for mounting on a flat surface (a lab bench, for example)
•
EZSwitchSetup CD
•
One set of HP StorageWorks product documentation including Safety Guides,
User License, Read Me First, and Warranty
•
For the 4/8 and 4/16 SAN Switches, one country-specific AC power cord
and one PDU power cord (not shown); for the 4/32, 4/32B and 4/64 SAN
Switches, two country-specific AC power cords and two PDU power cords
(not shown)
SAN Switch Rack Mount Kit rail assemblies:
•
Two rear mounting brackets
•
A right inner rail and a right outer rail
•
A left inner rail and a left outer rail
One of the following:
•
One HP StorageWorks 4/8 SAN Switch
Advertisement
Table of Contents
