HP AA-RWF3A-TE Installation Manual page 142

Table 30 Cabling pinouts
Pin
Signal
1
Not supported
2 RxData
TxData
3
4
Not supported
5 GND
6
Not supported
7
Not supported
8
Not supported
9
Not supported
A 3.0 m (10 ft) serial cable is provided with the switch. It can be converted from a DB-9
serial cable to an RJ-45 serial cable by removing the adapter on the end of the cable.
To remove the adapter from the end of the DB-9 serial cable:
1.
Ensure that the cable and both screws have been disengaged.
2.
Pull the adapter straight out, without moving it from side to side, to loosen the
seating of the connector. If you move the adapter side to side, you might damage it.
CAUTION:
When removing the DB-9 male connector from the DTE port, do not use excessive
force or the DB-9 connector will split into two parts easily to prevent damage to the
switch's DTE port.
142
SAN Switch technical specifications
Description
Not supported
Receive data
Transmit data
Not supported
Logic ground
Not supported
Not supported
Not supported
Not supported