Blacklist; Callback Settings - Yeastar Technology NeoGate User Manual

Call Destination
Hotline
Two stage Dial
Outbound Dial Pattern
Strip digits from front
before dialing
Prepend these digits
before dialing

7.3.3 Blacklist

Blacklist is used to block an incoming/outgoing call. If the number of incoming/outgoing
call is listed in the number blacklist, the caller will hear the following prompt: "The number
you have dialed is not in service. Please check the number and try again". The system will
then disconnect the call.
We can add a number with the type: inbound, outbound or both.

7.3.4 Callback Settings

NeoGate TG allows caller A to dial an inbound route number, and after hearing the ring, A
can hang up the call or wait for NeoGate TG to cut off the call, then NeoGate TG will call A
with this number. When A picks up the call, A can dial the number he wants to call;
NeoGate TG will route this call to destination trunk.
Notes:
1. If you'd like to use callback feature, please make sure it's enabled on the "Mobile to IP"
or "IP to Mobile" setting panel.
http://www.yeastar.com
NeoGate TG Series User Manual
Choose the destination trunk to route the call to
When it's configred, this number will be dial via
destination trunk permanently
Enable it to get the customized two stage dial tone
before dial out, it's disabled by default.
Outbound calls that match this dial pattern will use
this outbound route. Hover the pointer over
read tips.
Allows the user to specify the number of digits that
will be stripped from the front of the phone number
before the call is placed.
These digits will be prepended to the phone
number before the call is placed
Figure 7-34
to
53/56