Scope Of Delivery; Mains Connection; Battery Power Supply; Connection Of Peripheral Devices - KERN CPB 3K0.1 Operating Manual

7.2.2 Scope of delivery

Serial accessories:
• Balance
• Weighing plate
• Power cable
• Protective cover
• Internal battery
• Operating Manual

7.3 Mains connection

Power is supplied via the external mains power supply. The stated voltage value
must be the same as the local voltage. Only use original KERN mains power
supplies. Using other makes requires consent by KERN.

7.4 Battery power supply

The optionally supplied battery is charged with the supplied power supply.
Before the first use, the battery should be charged by connecting it to the mains
power supply for at least 15 hours. The operating time of the battery is about. 70h.
Charging time until complete recharging ca. 12h.
Selectable AUTO-OFF function after 1, 5, or 10 min (see chapt. 12).
If an arrow shows in the weight display [ ] above the battery symbol
the capacity of the battery will soon be exhausted. The balance will be ready to
operate for about another 10 min, then it will switch off automatically. Connect the
power supply as soon as possible to change the battery.
The LED display below the parts counting window informs you about the charge
status of the battery.
red:
green:
yellow: Battery should be charged over a longer period (over night)

7.5 Connection of peripheral devices

Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the balance from the power supply.
With your balance, only use accessories and peripheral devices by KERN, as they
are ideally tuned to your balance.

7.6 Initial Commissioning

A warming up time of 2 h after switching on stabilizes the measuring values.
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.
CPB-BA-defsi-0712
Battery is almost discharged
Battery is completely discharged
or "bat lo"
49