Throttle Body - Mitsubishi Lancer Evolution-IV Workshop Manual

THROTTLE BODY

REMOVAL AND INSTALLATION
Pre-removal Operation
(1) Engine Coolant Draining
(2) Air Hose D Removal
(Refer to GROUP 15 – Intercooler.)
(3) Strut Tower Bar Removal
19 {1.9}
3
6
Removal steps
1. Accelerator cable connection
2. Throttle position sensor connector
3. Idle speed control servo connector
4. Vacuum hose connection
Up
Towards front
of vehicle
MPI –
Throttle Body
2
4
5
INSTALLATION SERVICE POINT
"AA THROTTLE BODY GASKET INSTALLATION
Place the gasket so that the projecting part is positioned
as shown in the illustration, and then install it between the
intake manifold and the throttle body.
Post-installation Operation
(1) Strut Tower Bar Installation
(2) Air Hose D Installation
(Refer to GROUP 15 – Intercooler.)
(3) Engine Coolant Supplying
(4) Accelerator Cable Adjustment
7
5. Water hose connection
6. Throttle body
"AA 7. Throttle body gasket
13-37
5 {0.5}
1
Unit: Nm {kgf@m}