Mitsubishi Lancer Evolution-IV Workshop Manual page 143

22B-16
MANUAL TRANSMISSION OVERHAUL –
5th-reverse
shift fork
5th-reverse
shift rail
Output shaft
Center
differential
Output shaft
Center
differential
Solders
DISASSEMBLY SERVICE POINTS
AA" SPRING PIN REMOVAL
Shift the 5th-reverse shift fork in the direction shown in the
illustration.
AB" 3RD-4TH SPEED SHIFT RAIL / 3RD-4TH SPEED
3rd-4th
SHIFT FORK / 5TH-REVERSE SPEED SHIFT
speed
RAIL / 5TH-REVERSE SPEED SHIFT FORK
shift rail
REMOVAL
Pull out the shift rails from the shift rail holes in the clutch
housing.
AC" CENTER DIFFERENTIAL / OUTPUT SHAFT /
INPUT SHAFT REMOVAL
Input
shaft
Remove the input shaft, output shaft and center differential
together.
ADJUSTMENT BEFORE REASSEMBLY
Input SPACER SELECTION FOR ADJUSTING INPUT SHAFT
shaft
END PLAY / OUTPUT SHAFT PRELOAD /
DIFFERENTIAL PRELOAD
(1) Install the input shaft, output shaft and center differential
as a set to the clutch housing.
(2) Place two pieces of solder (1.6 mm in diameter and approx.
10 mm in length) on the input shaft rear bearing at the
positions shown in the illustration.
Transmission