Combination Meters - Mitsubishi Lancer Evolution-IV Workshop Manual

54-30
Circuit tester
Thermometer
10 – 12 Nm

COMBINATION METERS

REMOVAL AND INSTALLATION
1
Vehicle speed sensor removal
steps
D Battery and battery tray
D Air cleaner assembly
1. Vehicle speed sensor
CHASSIS ELECTRICAL –
ENGINE COOLANT TEMPERATURE GAUGE UNIT
CHECK
1. Bleed the engine coolant.
2. Remove the engine coolant temperature gauge unit.
3. Immerse the unit in 70_C water to measure the resistance.
4. After checking, apply the specified adhesive around the
5. Add engine coolant.
Combination Meters
Standard value: 104 ± 13.5 Ω
thread of engine coolant temperature gauge unit. Then,
tighten the unit to the specified torque.
Specified sealant:
3M Adhesive Nut Locking No. 4171 or equivalent
3
2
Combination meter removal steps
2. Meter bezel
3. Combination meter