Mitsubishi Lancer Evolution-IV Workshop Manual page 209

27-26
7-2 LISTING OF RESISTANCE AND CONTINUITY ACROSS CONNECTOR TERMINALS ON
HARNESS SIDE
(1) Measure the resistance and check for continuity with the ignition switch in the "OFF" position and
AYC-ECU connector disconnected.
(2) Measure the resistance and check for continuity across terminals listed below.
(3) Fig. below shows the arrangement of terminals.
Terminal No. Signal name
2 – body ground Longitudinal acceleration sensor ground, lateral acceleration sensor ground
26 – body ground ECU ground
35 – body ground AYC motor relay
37 – body ground Directional control valve (right)
38 – body ground Proportioning valve
45 – body ground Directional control valve (left)
46 – body ground ECU ground
2
6 – 19* Speed sensor (front, RH)
2
7 – 20* Speed sensor (front, LH)
2
8 – 21* Speed sensor (rear, RH)
2
9 – 22* Speed sensor (rear, LH)
NOTE
*2: Indicates the vehicles without ABS.
REAR AXLE –
Troubleshooting <AYC>
Normally
Conducting
Conducting
Conducting
15.4 – 16.4 Ω
3.4 – 4.0 Ω
15.4 – 16.4 Ω
Conducting
1.4 – 1.8 Ω
1.4 – 1.8 Ω
1.4 – 1.8 Ω
1.4 – 1.8 Ω