Recording Outgoing Messages - TIPTEL 308 clip Operating Instructions Manual

Recording outgoing messages

Select the desired OGM by pressing
the lower selection button.
Press the OGM button and keep it
pressed.
Start speaking your outgoing
message (keep a distance of about
15 cm from the microphone).
Release the OGM button to interrupt
the recording.
To continue recording your out-
going message, press the OGM
button again and keep it pressed.
Press the stop button to stop the
recording without saving.
Use the selection button next to the
corresponding line to determine
whether the OGM shall be with or
without an option for an incoming
message recording.
If you record OGM 2 as outgoing message without incoming recording
(announcement only), your tiptel 308 clip will automatically switch to this OGM
as soon as the recording capacity will be exhausted.
Outgoing messages (OGMs)
14
The selected OGM is shown at the
bottom right side of the display.
Wait, you will hear a brief tone, the
display shows "Recording".
The display shows the current duration of
your recording in minutes and seconds.
The display shows "Answer mode" and
"Answer only mode".
The recording is being continued.
The OGM recording is stopped.
The recording is complete and will be
played back for test purposes. An OGM
with incoming recording option is
indicated by just 1 signal tone at the end.
An OGM without incoming recording is
indicated by 2 signal tones.