Important safety instructions
Please read the user manual carefully and store in a handy
place for later reference.
Meanings of the symbols used in this manual are shown below:
This symbol indicates information concerning your
This symbol indicates information on how to avoid
damaging the appliance
tips and information
This symbol indicates tips and information about use
of the appliance
This symbol indicates tips and information about
economical and ecological use of the appliance
This symbol indicates never to do this
For your safety please read this book before
operating your barbecue.
Improper installation, adjustment, alteration or
maintenance can cause injury or property damage.
NOTE TO THE INSTALLER
THIS MANUAL MUST REMAIN WITH THE OWNER
FOR FUTURE REFERENCE
electrolux en:tice barbecue important safety instructions 3
IF YOU SMELL GAS, do not attempt to light the
barbecue. Locate the leak and re-tighten the leaking
joint. Carry out the Leak Test procedure as described in
this manual. If the leak persists, turn off the gas supply
and call Electrolux Service or a Licensed Gas Fitter.
D o not lean over barbecue when lighting.
Do not leave the barbecue unattended when alight.
Do not delay lighting once the gas has been turned on.
Do not store or use aerosol cans in the vicinity of
Do not store flammable liquids in the vicinity of
D o not use caustic or abrasive based cleaners on
Do not operate with optional weather proof
Do not attempt to dismantle or adjust the
Do not attempt to dismantle or adjust the regulator.
Do not test for leaks with a naked flame.
Do not modify the construction of this appliance
or modify the injector orifice size.
Do not obstruct any ventilation of the barbecue.
Do not allow children to operate or play near
This barbecue is supplied set up for Universal LPG
and is labelled accordingly. Universal LPG label
located inside barbecue cabinet on the RH side
panel. A Natural Gas conversion kit is available for
purchase from Electrolux Service or Spare Parts.
Conversion of this unit to Natural Gas must be carried
out by a qualified licensed person and a Certificate
of Compliance must be issued to the owner on
completion of the installation and conversion.