Electrolux EQBL100AS User Manual
Integrated barbecue
Hide thumbs
Also See for EQBL100AS:
- User manual (18 pages) ,
- Dimension and installation manual (1 page)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Electrolux EQBL100AS
Summary of Contents for Electrolux EQBL100AS
- Page 1 (EQBL100AS and EQBH100AS)
-
Page 2: Information On Disposal For Users
After unpacking the barbecue please check it is not damaged. If in doubt, do not use the appliance but contact your local Electrolux Customer Care Centre. Contents environmental tip Information on disposal for users... - Page 3 ii product description Integrated barbecue with slimline lid Integrated barbecue with roasting hood Slimline lid 2 Battery cover Gas connection point 4 Burner controls Grill assemblies x 2 sets Hotplate Removable oil reservoir located at front of cooking surface (not illustrated) Flame tamers x 2 located under grills (not illustrated) Roasting hood...
- Page 4 Parts Contents of your barbecue pack: left right Burner box & trim surround Rear heat shield Flame tamers 2 1 plastic bag containing this instruction book, labels, 4 ULPG injectors, allen key, ULPG adaptor, 2 fibre washers, natural gas installation pipe Oil reservoirs 1 LH (1 x left hand...
-
Page 5: Important Safety Instructions
Locate the leak and re-tighten the leaking joint. Carry out the Leak Test procedure as described in this manual. If the leak persists, turn off the gas supply and call Electrolux Service or a Licensed Gas Fitter. warning Do not lean over barbecue when lighting. -
Page 6: Assembling The Barbecue
Assembling the barbecue 1. Remove all components from box. 2. Attach heat shield to rear of unit by inserting the three top tabs into the rear holes and sliding the shield down. 3. Position flame tamers into desired locations (under where grill sections will be fitted) and fix back edge of the flame tamer into rear of barbecue body. -
Page 7: Gas Specifications
Gas specifications gas type natural gas Maximum gas consumption 50 MJ/hr Injector orifice diameter 1.75mm Number of injectors Regulator pressure 1.00 kPa NOTES a qualified licensed person. which requires the installation of venting to enable the barbecue to operate correctly. Failure to provide adequate ventilation for supply of air to the appliance may result in poor burner performance or excessive heat build-up within the mounting enclosure. -
Page 8: Universal Lpg Installation
Universal LPG installation Preparing the unit for Universal LPG installation. This barbecue is supplied set up for Natural Gas and is labelled accordingly. A Universal LPG conversion Kit is included to enable conversion to Universal LPG. NOTE out by a qualified licensed person and a Certificate of Compliance must be issued to the owner on completion of the installation and conversion. -
Page 9: Gas Bottle Safety Information
Gas bottle safety information designed to use a 9kg (20 lbs) gas cylinder. accordance with specifications for LPG cylinders appliance is not in use. out of reach of children. control valves are in the ‘OFF’ position. stored before disconnection. all connections are tight before replacing in the storage compartment. -
Page 10: Installation Warnings
6 installation warnings/installation instructions electrolux integrated barbecue Installation warnings warning open air situation with natural ventilation without stagnant areas, where gas leakage and product of combustion are rapidly dispersed by wind or natural convection. This barbecue has been designed for outdoor use only. - Page 11 diagram). required at the back of the barbecue between the splashback and the bench cut-out of 73mm minimum. This is to allow clearance for the hood to open. warning indicated below must be allowed for. A suitable grille can be fitted if desired. This vent area is to allow air into the enclosure for the correct combustion of gases and for the correct exhausting of the products of combustion.
-
Page 12: Gas Requirements
Gas requirements Natural Gas requirements be gained to the Natural Gas regulator at all times. connected to 1.2m flexible hose supplied and therefore must be located within this distance corresponding mating fitting will be required at the gas supply end. AS5601. -
Page 13: Options For Configuration Of Hotplates And Grills
Options for configuration of hotplates and grills important Ensure flame tamers are positioned under the grill panels grill panels flame tamers Left hand hotplate, right hand grill Left hand half grill, central hotplate, right hand half grill Left hand grill, right hand hotplate Operating instructions Control functions NOTE The slimline lid is designed as a cover for weather... -
Page 14: Cleaning And Care
Cleaning and care The Electrolux Integrated barbecue has been constructed from select grade stainless steel which, if not cared for, may discolour over time. To keep your barbecue looking its best we recommend that the cooking surfaces are cleaned after every use. -
Page 15: Maintenance
Manually light the barbecue Gently clean and dry electrode ensuring position is correct Turn gas valves down or turn off selected burners Turn off gas at the isolation valves Check for leaks, tighten joints If problem persists call Electrolux Service... -
Page 16: Warranty
Electrolux which cannot be excluded, restricted or modified. To the extent permitted by law, the liability of Electrolux (if any) arising out of or in relation to the Appliance or any services supplied by Electrolux shall be limited (where it is fair... - Page 18 Do you remember the last time you opened a gift that made you say “Oh! How did you know? That’s exactly what I wanted!” That’s the kind of feeling that the designers at Electrolux seek to evoke in everyone who chooses or uses one of our products. We devote time, knowledge, and a great deal of thought to anticipating and creating the kind of appliances that our customers really need and want.
Need help?
Do you have a question about the EQBL100AS and is the answer not in the manual?
Questions and answers