Screen Saver (Digital Picture Frame) Mode; Uploading Images To The Sd Card (Pc Only) - Lorex WIRELESS HOME MONITORING SYSTEM User Manual

Screen Saver (digital picture frame) mode

Screen Saver (digital picture frame) mode
Use the Screen Saver mode to conceal the fact that the wireless receiver is actually a
surveillance recorder.
Screen Saver mode has two options: blank screen or digital picture frame mode.
• In blank screen mode, the monitor will turn off when motion is not detected.
• In digital picture frame mode, you can upload personal images to the SD card and the monitor
will display them when motion is not detected.
In both modes, when motion is detected, the system will display the triggered camera in single
channel full-screen.
NOTE: You must connect the wireless receiver to a PC to use digital picture frame mode.
You cannot upload personal photos to the wireless receiver using a Mac computer.

Uploading images to the SD card (PC only)

You can connect the wireless receiver to a PC to upload personal images to the SD card for
digital picture frame mode. The built-in PhotoRun application automatically converts and
resizes your images to be compatible with the wireless receiver.
NOTE: The following image file formats are compatible with the wireless receiver: BMP,
JPG, TIF, and GIF.
NOTE: Photorun is compatible with the following versions of Windows: XP, Vista, 7.
To upload images to the SD card:
1 Press and hold the joystick on the rear panel of the wireless receiver. Keep the joystick held
down and connect the mini-USB cable between the monitor and your PC. Do not release the
joystick until "USB PC MASS STORAGE MODE" appears on the monitor.
NOTE: If "USB PC CAMERA MODE" appears on the monitor, remove the mini-USB cable
and wait for the system to restart. This may occur if the joystick is released before
the system can successfully enter USB Mass Storage mode.
28
mini-USB cable
USB Port
Press and hold joystick
while connecting the
mini-USB cable