Auto Sequence Viewing Mode; Quad Mode; Digital Zoom (Vga Only) - Lorex LW2760 Series User Manual

7 Using the System

7.3.1 Auto Sequence Viewing Mode

Auto Sequence Viewing mode cycles through connected channels in full-screen.
To enable Auto Sequence:
• Press until a single channel is shown on screen. The receiver automatically
switches through connected channels.
• Press to return to single channel viewing.

7.3.2 Quad Mode

Use Quad mode to view up to four cameras simultaneously.
To enable Quad mode:
• Press .
NOTE
If only two cameras are connected to the receiver, use Quad mode for a split-screen view (half-Quad
mode) that only shows the two channels being used.
Quad Mode

7.4 Digital Zoom (VGA only)

The digital zoom feature allows you to zoom in 2x on a single camera during live viewing.
This is useful if you need a closer look at something happening far away from the camera.
This feature is only available when the camera's resolution is set to VGA.
To use digital zoom:
1. Select the desired camera in full-screen mode (press
press on the front panel of the receiver to zoom in.
#LX400077; r.35258/35258; en-US
Half-Quad Mode
to select the channel) and
17