Configuring Screen Saver Mode - Lorex WIRELESS HOME MONITORING SYSTEM User Manual

Configuring Screen Saver mode

By default, Screen Saver mode is in Blank Screen mode. You can enable digital picture frame
mode and configure transition options for digital picture frame mode (PC only).
Prerequisites:
• To use digital picture frame mode, you must upload images onto the SD card. see "Uploading
images to the SD card (PC only)" on page 28.
To configure Screen Saver mode:
1 Press on the wireless receiver.
2 Press RIGHT/LEFT to select Screen Saver and
press OK.
3 Press UP/DOWN to select Blank Screen or
Photo Frame.
• If you press Blank Screen, when Screen Saver
mode is activated, the screen will turn blank
until motion is detected. Press
to live viewing.
• If you select Photo Frame, follow the steps below
to configure transition options.
4 Select Transition Timing and press OK. Select
the time that images will be shown before
switching and press OK.
5 Press DOWN to select Transition Options and
press OK. Select the transition effect that will be
used when switching images and press OK.
Available options are:
• Sequence: New image replaces the old image
in a scanning pattern.
• Push: New image pushes the old image out of
the frame.
• Split: New image splits the old image to replace
it.
6 Press until all menus are exited.
NOTE: The system will be in Auto Sequence mode when Screen Saver mode is disabled.
Screen Saver (digital picture frame) mode
to return
Select Blank Screen or Photo Frame for
digital picture frame mode
Configure Transition options for digital
picture frame mode
31