Table of Contents
Advertisement
Removing the bezel
Cover-release
latch
Key lock
Complete the following steps to remove the side cover of the server:
1.
Review the information in "Before you begin" on page 38.
2.
Turn off the server and peripheral devices and disconnect all external cables and
power cords.
3.
If necessary, unlock the server cover.
4.
Pull out on the cover-release latch, which will slide the cover toward the rear of
the server about 12.7 mm (1/2 in.). Then, remove the cover from the server.
5.
Pull out on the cover-release tab at the rear of the server; then, slide the cover
toward the front of the server and remove it.
Attention: For proper cooling and airflow, replace the cover before turning on the
server. Operating the server for extended periods of time (over 30 minutes) with the
cover removed might damage server components.
The following illustration shows how to remove the bezel from the server.
Note: The illustrations in this document might differ slightly from your hardware.
41
Installing options
Advertisement
Table of Contents
