Table of Contents
Advertisement
•
1.
Turn everything OFF.
2.
First, attach all cables to devices.
3.
Attach signal cables to connectors.
4.
Attach power cords to outlet.
5.
Turn device ON.
•
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
•
•
•
Dispose of the battery as required by local ordinances or regulations.
•
CAUTION:
When laser products (such as CD-ROMs, DVD-ROM drives, fiber optic devices, or
transmitters) are installed, note the following:
•
•
DANGER: Some laser products contain an embedded Class 3A or Class 3B laser
110
Hardware Maintenance Manual: xSeries 200
Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached devices.
To Connect
Statement 2
Throw or immerse into water
Heat to more than 100 C (212 F)
Repair or disassemble
Statement 3
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable parts
inside the device.
Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
diode. Note the following:
To Disconnect
1.
Turn everything OFF.
2.
First, remove power cords from outlet.
3.
Remove signal cables from connectors.
4.
Remove all cables from devices.
Advertisement
Table of Contents
